Accessories/Parts

Pair of EndCaps for Yakima CoreBar.

Pair of EndCaps for Yakima JetStream bars.

The control key is "uncut" and is used only for the removal and installation of an unlocked SKS core. Product Specs: - Weight: 0.02 lbs. - Limited Lifetime Warranty

Includes a single SKS key.

Chainstraps for a multitude of rear of car bike racks.

Safety and wheel straps for Joe Pro series strap racks. Includes one each.

Rear wheel strap for Boa bike mount. Includes one strap.

Spare part for SideWinder

End caps for 86" Cross Bars. Includes four end caps Please note these end caps are specific to the 86" cross bar.

Yakima's Chain Straps are replacement bike holding straps for various models of Yakima's trunk and hitch racks. The stretchy, sturdy rubber is easy on your bike's finish and is extremely durable for long life.

Thru-axle adapter for the Kuat TRIO rack.

Fat bike skewer and thru axle tube adapters for the Küat Trio roof rack.

SKS stands for "Same Key System." These types of cores enable you to lock all your Yakima products with just one key. When replacing a core on your Yakima product, you may need a Control key to remove your existing unlocked core so you can transfer the core to a different Yakima product.

- Fat straps are used to carry over sized (fat) tire bikes on Two/Four Timer bike racks. - Includes two straps - Weight: 0.44 lbs. - Dimensions: L 15.50 in x W 1.00 in x H 18 in

Piston Fender Strap Kit

- Installs easily in a truck bed or anywhere else you need a simple fork mount carrier

- Fits all Yakima crossbars except 86-inch - Sold in sets of 4

Body for HitchLock. Requires SKS lock core. (Sold Separately) - Weight: 1.00 lb

Make just about any accessory lockable with an SKS accessory housing. Use with bike, boat or BasketCase accessories that don't accept SKS lock cores. SKS lock cores sold separately. - Lock rack accessories to your vehicle's crossbar - Use with bike, boat, and BasketCase accessories - SKS Lock Cores sold separately Product Specs: - Weight: 0.20 lbs. - Dimensions: L 4.00 in x W 3.25 in x H 1.00 in - Limited Lifetime Warranty

The Thule Xadapt 7 Adapter Kit makes it possible to connect Thule carriers to Thule Professional load bars. Please contact us with any questions regarding compatibility.

The Thule Xadapt 8 Adapter Kit makes it possible to connect Thule carriers to Thule Professional load bars. Please contact us with any questions regarding compatibility.

Long loop strap provides anchor point for boat and load straps on vehicles without undercarriage attachment points. - Installs easily to available bolt heads under the hood - Boat bow & stern tie-down loops that are fastened inside the vehicle hood and protrude out through the edge to provide a secure loop to attach tie-downs

Thule's No-Sway Cages stabilize and prevent bike-to-bike contact on your hitch-mounted rack. They're only compatible with Thule's T3 cradles. You get 2 per pack (enough for 2 bikes).

Use these adapters to attach the LockNLoad platform directly to the Yakima TimberLine and SkyLine towers. They eliminate the need for a traditional crossbar, and put the platform lower and closer to the roof-giving your rig a clean, customized look. One pair of LockNLoad SL Adapters required for each pair of towers. Check your vehicle fit to verify requirements Product Details: - Sold as a set of 2 adapters with included hardware to attach to 2 Yakima TimberLine or SkyLine towers (towers sold separately). - Structural steel brackets with powder-coat finish for durability and resistance to the elements. - The LockNLoad platform requires 2 or 3 sets of adapters (check your vehicle's and platform's fit requirements for number of adapters needed). - Only compatible with Yakima SkyLine and TimberLine towers. - Each set of adapters adds 110 lbs. of weight capacity, up to 330 lbs., when used with 3 sets of adapters and towers. Never exceed the Yakima-specified weight limit for your vehicle. Product Specs: - Weight: 0.50 lbs - Some assembly required, 60 minute install

A set of extra-long replacement wheel straps to enable transport of very large-tire fat bikes. - Fits Thule EasyFold XT bike racks

The SkyHook gear hangers easily mount to your SkyRise rooftop tent to keep you organized at your campground. The simple to use carabiners slide into the SideTrack on the outside edge of the SkyRise floor to keep gear at an arm's length and off the ground. Sold in packs of four, each carabiner is supported with a nylon strap rated to handle up to 50 pounds. Jackets and wet towels, day packs and dry bags - whatever it is, the SkyHooks have got you covered. Product Details: - Hanging storage hooks for the SkyRise tent keep your camping gear organized - Slides into the SideTrack on the outside edge of the SkyRise base and hangs down below the tent floor to easily hold camping necessities - Yakima carbine attachment hook is secure, strong, and easy to use - Strong, durable nylon strap attached to each carabiner can support 50 pounds of gear - Sold as a pack of four Product Specs: - Weight: 0.48 lbs - Dimensions: L 6.00" x W 1.60" x H 0.50"

Long loop strap provides anchor point for boat and load straps on vehicles without undercarriage attachment points. - Installs easily by placing under hood or trunk and is secured by the closed lid - Boat bow & stern tie-down loops that are fastened inside the vehicle hood or trunk hatch and protrude out through the edge to provide a secure loop to attach tie-downs to

The LongArm Pad provides some extra protection when hauling gear on Yakima's LongArm truck bed extender. The pad combines durability and protection with a soft foam core and a ballistic nylon exterior that holds up over time. Hook and loop closures are designed to hug the LongArm’s crossbar tight and a center cutout allows side or centered placement. Sold as a single pad. PRODUCT DETAILS - Foam padding protects boats and other cargo from damage - Durable, ballistic nylon construction - Look and loop closures and 28” length perfectly fit around the LongArm crossbar - Center cutout allows side or centered placement on crossbar - Sold as a single pad TECHNICAL SPECS - Weight: 0.50 lbs - Dimensions: L 28.00in x W 3.00in x H 3.00in

Why let loading and unloading take a toll on your gear and rack systems? Our new, extra-thick Wear Strip is a raised rubber strip designed to protect equipment and T-slot crossbars. Sold in trim-to-fit pairs, the Wear Strips install easily and help keep out debris. Product Details: - Durable rubber strip protects gear and crossbars from the wear-and-tear of loading - 76" length can be easily trimmed to fit any bar width - Compatible with Yakima HD Bar and JetStream Crossbars - Set of two Product Specs: - Weight: 0.50 lbs - Dimensions: L 76.00in x W 1.12in x H 0.33in - Fully assembled

Yakima's Hood Anchor creates a secure attachment point at your hatch, trunk or hood for bow and stern tie downs. Sold in pairs, they’re highway-speed strong, coated to protect your vehicle’s paint job, and super easy to use - just drop them in place. Product Details - Creates a secure attachment point for bow and stern tie downs - Fits easily under a hood, hatch or trunk - Installation is simple - just drop them in place - Durable coated strap protects your vehicle's paint - Sold as a pair Technical Specs - Weight: 0.43 lbs - Dimensions: L 6.50in x W 2.00in x H 10.12in